Fleece Earmuff Cap
Material: 100% Polyester (Polartec® Wind Pro®)
Size: One size, depth approx. 17.5cm (when laid flat), eaves length approx. 6cm, head circumference approx. 59cm (adjustable with rubber)
*There may be an difference of about ±1cm in the size of the product.
Colors: Olive / Navy / Black / Sallow
Weight: about 68g
Country of Origin: Japan
Producer: Shimada Co., Ltd., Kanonji City, Kagawa Prefecture
Material:
This product uses Polartec® Wind Pro®. Wind Pro® is a fleece material with improved cold protection. The tightly woven knit construction protects against the cold while maintaining breathability. The surface of the fabric is flat and has a soft touch impression. It is also windproof and water repellent, allowing heat and steam from the body to disperse and escape.
Introduction:
"Fleece Earmuff Cap" is a product with the same as "Grid Merino Earmuff Cap". "Grid Merino Earmuff Cap” is not completely windproof due to the characteristics of the fabric. It is assumed that it will be used during winter activities. The head part allows air to pass through and prevents overheating. It is not windproof like synthetic fleece. On the other hand, this "Fleece Earmuff Cap" is both windproof and water repellent. If you hike while wearing this cap, you could feel warm in the journey. "Fleece Earmuff Cap" is recommended for winter caps where there is a lot of stagnation.
"Fleece Earmuff Cap" aim at completely cover the head, ears, and back of the head. The design of the main body is the same as the design of the “Basic Cap”, and the design of the main body is a basic 6-piece joint. In contrast to the design with a shallow body and short eaves like a cycle cap, the body is loose and deep, and the eaves part is not too affected by the wind, and Ridge Mountain Gear aimed for a length that can be expected to have a sunshade effect.
The "Basic Cap" was created with the aim of creating a cap for who has a slightly larger head can wear it without stress. Therefore, the head size (head circumference) is a little looser than a general cap.If the product size is larger than your head size (head circumference) or if it is easily affected by wind, you can adjust the size by pulling the plastic tab on the back and tightening the rubber.
For the ear pads, the fabric is folded in two on the back and used in two pieces. It keeps the ears and the back of the head warmer than the one-piece head part.
You can wear it in various ways by changing the earpiece part for each situation. If you don't need the ear pads, fold them up and cover them.
The sweatband uses COOLMAX® fabric. Made of 100% pique-shaped polyester material, it has the function of water absorption, quick drying and UV protection (UPF 40+).
*Attention
・Please turn the product inside out and put it in a laundry net and wash it separately.
・The water temperature should be limited to 40°C, and avoid washing with hot water.
・Use a neutral detergent and do not use bleach or fabric softener.
・Avoid tumble drying.
・Dry cleaning is not allowed.
・Do not iron.
・After dehydration, we recommend reshaping and drying in the shade.
*photo credit: Ridge Mountain Gear official website(https://www.ridge-mountaingear.com/)
*Product information translated by morimori
Material: 100% Polyester (Polartec® Wind Pro®)
Size: One size, depth approx. 17.5cm (when laid flat), eaves length approx. 6cm, head circumference approx. 59cm (adjustable with rubber)
*There may be an difference of about ±1cm in the size of the product.
Colors: Olive / Navy / Black / Sallow
Weight: about 68g
Country of Origin: Japan
Producer: Shimada Co., Ltd., Kanonji City, Kagawa Prefecture
Material:
This product uses Polartec® Wind Pro®. Wind Pro® is a fleece material with improved cold protection. The tightly woven knit construction protects against the cold while maintaining breathability. The surface of the fabric is flat and has a soft touch impression. It is also windproof and water repellent, allowing heat and steam from the body to disperse and escape.
Introduction:
"Fleece Earmuff Cap" is a product with the same as "Grid Merino Earmuff Cap". "Grid Merino Earmuff Cap” is not completely windproof due to the characteristics of the fabric. It is assumed that it will be used during winter activities. The head part allows air to pass through and prevents overheating. It is not windproof like synthetic fleece. On the other hand, this "Fleece Earmuff Cap" is both windproof and water repellent. If you hike while wearing this cap, you could feel warm in the journey. "Fleece Earmuff Cap" is recommended for winter caps where there is a lot of stagnation.
"Fleece Earmuff Cap" aim at completely cover the head, ears, and back of the head. The design of the main body is the same as the design of the “Basic Cap”, and the design of the main body is a basic 6-piece joint. In contrast to the design with a shallow body and short eaves like a cycle cap, the body is loose and deep, and the eaves part is not too affected by the wind, and Ridge Mountain Gear aimed for a length that can be expected to have a sunshade effect.
The "Basic Cap" was created with the aim of creating a cap for who has a slightly larger head can wear it without stress. Therefore, the head size (head circumference) is a little looser than a general cap.If the product size is larger than your head size (head circumference) or if it is easily affected by wind, you can adjust the size by pulling the plastic tab on the back and tightening the rubber.
For the ear pads, the fabric is folded in two on the back and used in two pieces. It keeps the ears and the back of the head warmer than the one-piece head part.
You can wear it in various ways by changing the earpiece part for each situation. If you don't need the ear pads, fold them up and cover them.
The sweatband uses COOLMAX® fabric. Made of 100% pique-shaped polyester material, it has the function of water absorption, quick drying and UV protection (UPF 40+).
*Attention
・Please turn the product inside out and put it in a laundry net and wash it separately.
・The water temperature should be limited to 40°C, and avoid washing with hot water.
・Use a neutral detergent and do not use bleach or fabric softener.
・Avoid tumble drying.
・Dry cleaning is not allowed.
・Do not iron.
・After dehydration, we recommend reshaping and drying in the shade.
*photo credit: Ridge Mountain Gear official website(https://www.ridge-mountaingear.com/)
*Product information translated by morimori
Material: 100% Polyester (Polartec® Wind Pro®)
Size: One size, depth approx. 17.5cm (when laid flat), eaves length approx. 6cm, head circumference approx. 59cm (adjustable with rubber)
*There may be an difference of about ±1cm in the size of the product.
Colors: Olive / Navy / Black / Sallow
Weight: about 68g
Country of Origin: Japan
Producer: Shimada Co., Ltd., Kanonji City, Kagawa Prefecture
Material:
This product uses Polartec® Wind Pro®. Wind Pro® is a fleece material with improved cold protection. The tightly woven knit construction protects against the cold while maintaining breathability. The surface of the fabric is flat and has a soft touch impression. It is also windproof and water repellent, allowing heat and steam from the body to disperse and escape.
Introduction:
"Fleece Earmuff Cap" is a product with the same as "Grid Merino Earmuff Cap". "Grid Merino Earmuff Cap” is not completely windproof due to the characteristics of the fabric. It is assumed that it will be used during winter activities. The head part allows air to pass through and prevents overheating. It is not windproof like synthetic fleece. On the other hand, this "Fleece Earmuff Cap" is both windproof and water repellent. If you hike while wearing this cap, you could feel warm in the journey. "Fleece Earmuff Cap" is recommended for winter caps where there is a lot of stagnation.
"Fleece Earmuff Cap" aim at completely cover the head, ears, and back of the head. The design of the main body is the same as the design of the “Basic Cap”, and the design of the main body is a basic 6-piece joint. In contrast to the design with a shallow body and short eaves like a cycle cap, the body is loose and deep, and the eaves part is not too affected by the wind, and Ridge Mountain Gear aimed for a length that can be expected to have a sunshade effect.
The "Basic Cap" was created with the aim of creating a cap for who has a slightly larger head can wear it without stress. Therefore, the head size (head circumference) is a little looser than a general cap.If the product size is larger than your head size (head circumference) or if it is easily affected by wind, you can adjust the size by pulling the plastic tab on the back and tightening the rubber.
For the ear pads, the fabric is folded in two on the back and used in two pieces. It keeps the ears and the back of the head warmer than the one-piece head part.
You can wear it in various ways by changing the earpiece part for each situation. If you don't need the ear pads, fold them up and cover them.
The sweatband uses COOLMAX® fabric. Made of 100% pique-shaped polyester material, it has the function of water absorption, quick drying and UV protection (UPF 40+).
*Attention
・Please turn the product inside out and put it in a laundry net and wash it separately.
・The water temperature should be limited to 40°C, and avoid washing with hot water.
・Use a neutral detergent and do not use bleach or fabric softener.
・Avoid tumble drying.
・Dry cleaning is not allowed.
・Do not iron.
・After dehydration, we recommend reshaping and drying in the shade.
*photo credit: Ridge Mountain Gear official website(https://www.ridge-mountaingear.com/)
*Product information translated by morimori